Gen 3 ride height sensor

[FordTechOne]

Evening. I did the reset just now and each tire is showing -1.00.
Have you seen this on all 4 readings before?

Is the truck modified?

 

[pirates1456]

Is the truck modified?

Just installed 2.25 RPG collars and RPG 1 inch rear spacer and 37's. Nothing other than that. I did screw up and was sitting in the truck while I did it last night.

 

[FordTechOne]

Just installed 2.25 RPG collars and RPG 1 inch rear spacer and 37's. Nothing other than that. I did screw up and was sitting in the truck while I did it last night.

That’s likely your issue, the system isn’t designed to accommodate lifts. Some others have had to disconnect the ride height sensors and manually move them within range to get the calibration to complete.

 

[pirates1456]

That’s likely your issue, the system isn’t designed to accommodate lifts. Some others have had to disconnect the ride height sensors and manually move them within range to get the calibration to complete.

Got it. Thanks for the response

 

[Michael Herdershot]

That’s likely your issue, the system isn’t designed to accommodate lifts. Some others have had to disconnect the ride height sensors and manually move them within range to get the calibration to complete.

That’s likely your issue, the system isn’t designed to accommodate lifts. Some others have had to disconnect the ride height sensors and manually move them within range to get the calibration to complete.

This might be the answer I have been searching for. Are you stating that others have simply unplugged and physically turned the pegs to the middle and then plug them back in? Is there a thread I am missing on this? Did Eibach pro lift. Then forscan. Can’t get it back to previous file settings. Now getting C1124 code. Took to dealer and they can’t get it back either. Huge help if you know. Was planning to get this all figured out and put the solution on Forscan ride height thread but not there yet and suspension drives like a brick since I did Forscan.

 

[FordTechOne]

This might be the answer I have been searching for. Are you stating that others have simply unplugged and physically turned the pegs to the middle and then plug them back in? Is there a thread I am missing on this? Did Eibach pro lift. Then forscan. Can’t get it back to previous file settings. Now getting C1124 code. Took to dealer and they can’t get it back either. Huge help if you know. Was planning to get this all figured out and put the solution on Forscan ride height thread but not there yet and suspension drives like a brick since I did Forscan.

Not sure, that’s just what other people have mentioned. When it comes to mods I avoid them like the plague.

 

[Michael Herdershot]

Not sure, that’s just what other people have mentioned. When it comes to mods I avoid them like the plague.

Got it. Thanks. Probably the wiser