Front Bumper - Any DFW area guys have a stock one?

[MotuMute]

While waiting for my bumper build, I might as well tidy up my truck's front end. Anyone local have one I can buy? Thanks, John

 

[Yukon Joe]

Don't you mean barrow?

Joe

 

[CAbimmer]

I have one, it has a very small dent by the drivers side tow hook hole

 

[MotuMute]

Don't you mean barrow?

Joe

Hate to "borrow" something so easily destroyed haha. My stocker was never right after TRR - got shoved up and back on the right side. Ryan over at Rock&Roll has this big prybar and did his best to disguise the damage. But now... it's just ready for the scrap heap. It might take a little time to design and fab something with just the right look I'm going for, so meanwhile I might as well clean up my act a bit. I'm just sure nobody would want it back when I'm done with it.

---------- Post added at 07:35 AM ---------- Previous post was at 07:31 AM ----------

I have one, it has a very small dent by the drivers side tow hook hole

That will do just fine! I'll send ya a PM

 

[CAbimmer]

My replacement

 

[MotuMute]

Great choice! Looks good. Might have gone that route, but it just doesn't fit in my oldtimey tiny damn garage...

 

[CAbimmer]

I had this made without the front push bar, fits in mine with about 3" to spare

 

[Phyguy]

My replacement

Is it aligned right? Looks like the gap enlargens as it follows the curve of the front end. Looks good as I've always loved that bumper.

 

[CAbimmer]

That was when I first put it on. I spent some time getting it aligned better a week or so after the picture. With aftermarket bumpers you remove the supports for the lower painted grill area and it sags down. I fabed up some brackets to raise it back up. Looks much better

 

[MotuMute]

Hey Doug, still wanna part with your takeoff stock bumper? If so, I PM'd you my number.
Thanks, John