F/S: [Group Buy] Rear Facing Amber Light Bar

[Big Blue]

Waiting for UPS to deliver trim edging, so I started working on the other project.

KC white Cyclone mobile Work Light. Used a Quick Fist clamp and with 25' of wire, it can go anywhere. Also plugs into 12V outlet and has 2,200 lumens.

 

[Deleted member 12951]

You kept making all this cool shit, take my money!!

 

[Ftlombard]

Ok how much for this one................

 

[AbnMP13]

Yeah what he said.

 

[Big Blue]

You kept making all this cool shit, take my money!!

Ok how much for this one................

Yeah what he said.

Haha, you guys are great. Thanks. Its the first demo, I already know how to make a minor improvement and I plan on adding 25' of sleeving over the wire to protect it.

I'm thinking $125 shipped once I have the market version ready.

Damn UPS never dropped off the edging, I'm sure it will be here tomorrow. Still shooting for a Friday mailing on the first group.

I ordered all the Cyclones for the second group today too.

 

[AbnMP13]

Is there a switch on the work light?

 

[Big Blue]

Is there a switch on the work light?

No, just a similar 12V plug. Nice idea though, although I made the bracket just big enough for the Cyclones, not sure where to place a switch though? I would think you would want it close to the light, not the plug. I will have to sleep on it. I'll put edging around this too so it has no sharp/hard edges.

 

[AbnMP13]

Maybe an inline switch?

 

[Ftlombard]

I am in for the next project too......whatever you are planning to make.

 

[Big Blue]

First group is ready for shipping and will go out tomorrow. For the guys in group A, if you haven't PMed me your Address, please do that.

Front:


Back:



You can see the edging better in this pic. I already put the Zip ties on in the appropriate spots but did not lock them. This way you do not even need to remove the headrest to install.

Install:

1) Raise center rear Headrest to highest point.

2) Align Light bar against back of poles and up against bottom of headrest.

3) Tighten Zip tie tightly around each pole and cut off excess.

4) Lower headrest to desired level or all the way back down.

5) Run wire down and under seat/floor mats and plug into 12V plug.

Enjoy.