Electronic blow off valve connector

[Guy]

Hey Guys...

So I haven’t finished my Gearhead review because I decided to drop the intercooler down and adjust my clamps and fix a little rattle.

When I dropped it this time, I snagged the wire that goes to the blow off valve.

It pulled out from “somewhere” and I can’t figure out where it yanked from to fix it.

Brown with a white stripe and grey and it connects to the BOV and acuates it.

I’ll include a pic. What’s killing me is that it’s short and yet I can’t see where it pulled ouT.

Can anyone shed some light so I can button this back up and finish my review?


Thanks!

 

[solarwinds]

front lower grill section runs along top line where top of cac front ends up on driver side

 

[Guy]

Are you able to elaborate further?

The two little wires pulled out from “something” a harness?

Not sure what you mean.

Could use the help!

Thanks

front lower grill section runs along top line where top of cac front ends up on driver side

 

[solarwinds]

Are you able to elaborate further?

The two little wires pulled out from “something” a harness?

Not sure what you mean.

Could use the help!

Thanks

check out step 12 of the whipple install guide. has a color pic of the run

 

[Guy]

I found it.

It pulled out of a connector that clips up front.


Now that I found it.

Not a big deal.

Thanks for giving me the heads up!

 

[k-rub]

Out of curiosity, did you find the rattle? I've been chasing a small rattle for a bit. It's hard to narrow down but coming from the same area.

 

[Guy]

I dropped down the intercooler,

Checked every bolt for tightness... hit a little WD40 in every joint, retaining clip, I could find and added a zip tied to every stray cable or harness.

Of course as you see above... I snagged the wire harness and thanks to old Solar.. I found the connector it pulled from up on the front bumper.... I pulled it out, soldered that bad boy back in place... and then shrink wrapped everything. Won’t happen again.

Anyway. I just finished buttoning everything up and I took it for a 15 minute drive. So far.... no rattle.... except for the shrunken brain inside my skull... I now have from laying on the ground in 15 degrees all day.

 

[bc75]

Hey Guys...

So I haven’t finished my Gearhead review because I decided to drop the intercooler down and adjust my clamps and fix a little rattle.

When I dropped it this time, I snagged the wire that goes to the blow off valve.

It pulled out from “somewhere” and I can’t figure out where it yanked from to fix it.

Brown with a white stripe and grey and it connects to the BOV and acuates it.

I’ll include a pic. What’s killing me is that it’s short and yet I can’t see where it pulled ouT.

Can anyone shed some light so I can button this back up and finish my review?


Thanks!

I just bought a truck that was wrecked. The wire the blow off valve hookes to is missing. Do you know the part number and were it hooks to.