Centre speaker connector

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Kahuna

THE MORE YOU PLAY WITH IT, THE BIGGER IT GETS
Joined
Aug 31, 2014
Posts
872
Reaction score
795
Does anyone have a bead on what it is and a source for the connector for the centre speaker? I want to use the speaker for my VHF install but don't really want to cut any wires.

Thanks,
K
 

Rookie

Supporting Vendor
Supporting Vendor
Joined
Dec 16, 2012
Posts
9,760
Reaction score
3,594
Location
Fort Wayne, IN
I soldered right to the posts and just disconnected the factory connector. No cutting that way.



Click here to bid on a spot for the Snoball 2016 with proceeds going to stand up Dub!

freedommotorsports.us

Email: [email protected]


FreedomLogo.jpg

 

DocSpooK

Full Access Member
Joined
Feb 27, 2011
Posts
506
Reaction score
431
Location
TechsAzz
I can't solder for crap, so just cut it down stream and twisted on the new ones with electric tape. never had an issue doing this and enough slack to undo if ever needed. Works well for the radio.
 

RaptorScrew

FRF Addict
Joined
Mar 12, 2011
Posts
3,213
Reaction score
1,903
Location
Oronoco, MN
OP
OP
Kahuna

Kahuna

THE MORE YOU PLAY WITH IT, THE BIGGER IT GETS
Joined
Aug 31, 2014
Posts
872
Reaction score
795
Thanks for the input guys but if I can get hold of one I would like to use a connector.

I installed my VHF radio in the Center Speaker area and remove it when not in use.

Will you leave it installed 24/7?

My radio head is installed up near the sunglasses holder but I need to connect an external speaker. I want to use the OEM centre speaker so am trying to track down the connector on the harness side of the speaker wiring. That way I can connect my VHF to that and easily switch back to using the speaker for the stereo.

The head unit is cut into the headliner so stays there 24/7.

Thanks,
K
 

McGrath4u

Full Access Member
Joined
Dec 23, 2014
Posts
302
Reaction score
223
I wanted the clean look and searched near and far for a connector to mate the existing center speaker but came up short. Ended up unsoldering the factory connector and soldering in 2-wire trailer connectors to both the radio and uhf/vhf radio. Can swap back and forth in about 1 minute.

Hillbilly? Yes but I was sick of searching junk yards and specialty electronic stores. Just wanted it done at that point.


Sent from my iPhone using Tapatalk
 
Top