Bumper Fitment

[DMM_78]

The driver's side exhaust tip is about 1 in past the bumper. The passenger's side is flush. It's the bumper itself. There's about a 1 in gap between the bumper and bed on driver's side and about a 2 in gap on the passenger's side. Has anyone else had this on their truck?

 

[MattR]

Ongoing issue with these trucks

 

[DMM_78]

I stopped by the dealer this afternoon and they said it's not the bumper. The bumper fitment is identical to one on the lot. They said the exhaust was fabricated incorrectly and there's no way to adjust it.

 

[MORK]

Sounds like your dealer doesn’t feel like turning a wrench.

 

[Littlefx4]

Is that pic directly from the side or is your angle off a lil bit? Pic of pass side for comparison?

 

[DMM_78]

 

[DMM_78]

It's about a 1 in difference.

 

[HighwaySentinel]

Dealer sounds a little lazy. You might have to get underneath, loosen the clamp and make sure it is seated as far in as it will go. Or go to a different dealer.

 

[downforce137]

its probably in the over the axle clamp. what do the hangers look like back there?

 

[figure1a]

Sounds like your dealer doesn’t feel like turning a wrench.

2nd this. Someone else on this forum had the same issue. Dealer fixed it but said it was a major PITA to loosen the exhaust system and adjust that 1".