Bump stop issue

[Raptor 2014]

The ones I have on there are Fox 2.5 bump stops.they make two different versions I believe I have the 4-in. I think if I swap them out with their other version which is 2 and 1/2-in that gives me a couple inches more rear suspension travel before it hits the stop.

Don't swap them out try lowering the pressure to 80PSI - I think you will be Good to go.

 

[Matts6foot8]

Just lowered the psi today to 100. Haven't driven it hard enough to find out but I'm sure it'll be better.

 

[ogdobber]

2nd picture

View attachment 155447

I was thinking at first your spring looks flat compared to mine but mine are +3s with an inch drop with the longer shackles. So yours are for sure +2s. However look at my bump stop “holder”, it’s way higher. So your bumps are too long for that design.
Also it takes a big hit before I touch my bumps

 

[Matts6foot8]

Now that looks correct. On mine I think the cross member/sleeve that holds the stops is too low like you said.

 

[ogdobber]

Now that looks correct. On mine I think the cross member/sleeve that holds the stops is too low like you said.

I think your bump stop holder uses 2.0s and not 2.5s
2.0s are 1.5 inches shorter and that would definitely get you closer to 5 inches
Mine is 5 1/2 but it sits pretty high in the back



Sent from my iPhone using Tapatalk Pro

 

[ogdobber]

Can you take a pic from the back left like mine? I wanna have a better look. Maybe figure out the brand


Sent from my iPhone using Tapatalk Pro

 

[Matts6foot8]

Okay so the shaft is 1 3/4 wide. I measured the shaft that is exposed for the amount of travel and it measures 2 1/2 inches. The bump stop total width is 2 1/2 inches.

 

[Matts6foot8]

Here's another

 

[Matts6foot8]

Here is a picture of the mount/cross member. I'm thinking the previous owner got a package deal with them together.

 

[ogdobber]

Here is a picture of the mount/cross member. I'm thinking the previous owner got a package deal with them together.

View attachment 155515

You probably need new bumps or a new bracket
That ready lift bump kit uses 980-02-801 for the bump which is a 2.5 but the overall length is 10” vs the one you have which looks like the length similar to mine which is 11” (part # 980-02-311 ) However 10” is still too long and you would be better off with a 2.0 (overall length is 9.66)

Edit- or cut and weld the bump cylinder higher



Sent from my iPhone using Tapatalk Pro