Builtright rear seat release

[jonfo]

Got this and it works well, never seem to have to lineup the latch in the back. Not sure why but my seat kept flipping forward and after I put this one not having any problems.

https://www.amazon.com/dp/B0732VMKHM/?tag=fordraptorforum-20

 

[Ox3721]

Same here.

I’ve found that by pushing the sliding latch part (connected to the cab) down about 1/4” before pushing the seat back, it will latch.

I think it’s being raised slightly when the seat is folded down.

Perhaps that piece needs a little “break-in” or lube and it will take care of itself?

 

[SkyPilot]

I used the BuiltRight latch on my Gen2 SCAB and it works great! Good luck getting the seat down without it!

 

[pat247]

I used long zip ties cut to length for years then downgraded to the builtright rear seat release. The nylon strap is so cheap looking I doubt dollar tree would carry it in their stores. Needless to say I normally don't mention I have one, it was a gift so it's in for now.

 

[cmstric]

Got this and it works well, never seem to have to lineup the latch in the back. Not sure why but my seat kept flipping forward and after I put this one not having any problems.

https://www.amazon.com/dp/B0732VMKHM/?tag=fordraptorforum-20

This is working on the gen3 well? What is the point to fold down? Good amount of storage there?

 

[PandaBoi]

Ive also had issues with it, always have to move it to get to the perfect position so the back clicks in. Often don’t get it the first try. Zip tie sounds like a great alternative though.

 

[AutoXRacer]

Which seat are you guys referring to?
The right and left seat do not operate the same.

There is a sequence to the left rear seat...

 

[AutoXRacer]

 

[Spooky]

Ive also had issues with it, always have to move it to get to the perfect position so the back clicks in. Often don’t get it the first try. Zip tie sounds like a great alternative though.

I found that if the Build Right cover is too tight to the extender, it'll get hung up a bit and not allow the latch to reengage easily. I simply adjusted it over a bit and tightened it and it works great.

 

[PandaBoi]

I found that if the Build Right cover is too tight to the extender, it'll get hung up a bit and not allow the latch to reengage easily. I simply adjusted it over a bit and tightened it and it works great.

I’ll have to give that a try