GEN 2 Bora Wheel Spacers Installed

[FlyingRaptor]

I bought some Bora wheel spacers from @BBLV here on the forum and installed them on my 18 Raptor along with upgraded 19 Beadlock Wheels. Install was simple and didnt take more than an hour to complete.


I first removed the wheels and clean up surface area of wheels and rotors.







Then I used red loctite and installed the lug nuts that came with the spacers to 150 lbs/ft.

 

[FlyingRaptor]

I then Installed the wheels onto the spacer and torqued the lug nuts to 150 lbs/ft.

This is a picture without the spacers installed.



Here are some pictures with the spacers installed.

 

[STP]

Just put 1.5" spacers on my 2011 Gen I. Pushed them out just right. I think 2in would have been too much and an inch not enough. Your stance looks good!

 

[FlyingRaptor]

Just put 1.5" spacers on my 2011 Gen I. Pushed them out just right. I think 2in would have been too much and an inch not enough. Your stance looks good!

Thanks! It definitely gives it a more aggressive stance and look.





View attachment 124863

 

[GR8Ride]

Thanks! It definitely gives it a more aggressive stance and look.

View attachment 124861

View attachment 124862

View attachment 124863

Looks good!! What size spacers did you go with?
Thanks


Sent from my iPhone using Tapatalk

 

[FlyingRaptor]

Looks good!! What size spacers did you go with?
Thanks


Sent from my iPhone using Tapatalk

I used the 1.5" spacers.

 

[BBLV]

Perfect!!

 

[Johnkn]

Did you have to trim the factory rear wheel studs? I have a set of 1.25" Boras being delivered this week.

 

[FlyingRaptor]

Did you have to trim the factory rear wheel studs? I have a set of 1.25" Boras being delivered this week.

I did not have to trim the studs, but I have the 1.5" spacers. Below is a picture showing how far they stuck out with the 1.5's. There is a recess in the factory wheels so there might be enough room with yours sticking out an extra 1/4".

 

[Johnkn]

Ok, thanks, I have the same 19 wheels. Does Bora recommend red locktite? I was going to use the blue as they will need to be removed during brake service. Thanks