GEN 2 Anyone Run this SVC Stage 1 Starter Setup??

[WillieFlo]

Does anyone have this on your Gen 2 w Deaver +3” ?? How does it ride?
https://svcoffroad.com/collections/...ts/stage-1-starter-kit?variant=28556660768846

 

[Dustan]

I have the deavers and SVC bump stop kit. Everything lined up and was an easy install. I haven’t had any issues. I wish you didn’t have to grind off the ABS sensor line attachment to mount the bump plate. But they give a spot to mount the line

 

[WillieFlo]

I have the deavers and SVC bump stop kit. Everything lined up and was an easy install. I haven’t had any issues. I wish you didn’t have to grind off the ABS sensor line attachment to mount the bump plate. But they give a spot to mount the line

Dustan, Are you running 37's on yours? Also, are hydra bumpstops not needed on the front?

 

[Dustan]

I’m running 35’s. I’ve seen front bumps but I don’t think I’ll ever get to that level

 

[Clockton]

SVC all the way.

 

[Peterb]

so if the op is fairly serious, the deavers and bump stop is permanent but you probably at least want eibach or geiser springs at the front instead of a collar, new shackles would be smart too

 

[Raptor430]

SVC produces some high quality parts, I ran this setup with their billet uppers until my 3.0 live valve shocks came in and it performed very well. I recommend you not crank the CAS system up too high, it will cause the ride to get pretty bouncy up front. I went with the Fox 2.0 ifp bumps.

 

[Jace21583]

Ugh... Why would you run collars over springs in the front??? Because svc doesn't make a front spring?? Lol

 

[WillieFlo]

Wow, there’s a lot more involved than just bolting on that kit.....my head hurts already....crap!

 

[Dirt_Crusted_Raptor]

Ugh... Why would you run collars over springs in the front??? Because svc doesn't make a front spring?? Lol

Would you suggest doing the SVC rear portions (deavers and bump stops) and then run springs in the front? The truck would ride better I take it?