All about rims

[Kraka]

That's no good Bird.

 

[shayneshow]

i love my Addicts and they are easy to keep clean except around the bolt looking things i just use a soft bristled scrub brush and some dish liquid. the finish on them is very durable...however the 3 alan head screws that hold the center cap on are beginning to rust.

That's what you get for Chinese ****... I wish everything was made in America... Very often I put things down in stores and refuse to buy them when i see MADE IN CHINA... USA all the way. (Pretty patriotic coming from a Canuck)

 

[BOJANGLES]

Hey Iron, sorry for the late reply.... what I had said is that the Grabber lettering looks somewhat pink when the tires are dirty. Black tire grime + dirt seems to = pink on mine anyway. When i clean 'em back up, they look more red again. And yes, they are only red on one side, so you can run the red side out OR the black side out.

 

[IRONMAN]

Hey Iron, sorry for the late reply.... what I had said is that the Grabber lettering looks somewhat pink when the tires are dirty. Black tire grime + dirt seems to = pink on mine anyway. When i clean 'em back up, they look more red again. And yes, they are only red on one side, so you can run the red side out OR the black side out.

How do you like them so far?

 

[Kraka]

That's what you get for Chinese ****... I wish everything was made in America... Very often I put things down in stores and refuse to buy them when i see MADE IN CHINA... USA all the way. (Pretty patriotic coming from a Canuck)

I hate to say it, but sometimes the Chinese shit is better made than the American shit and cheaper. I am all about American made and I wil support as much as I can, but sometimes the quality just isn't there.

Being in the USCG, we are not allowed to buy anything at work from China unless it has been pre-approved by some higher power.

 

[Kraka]

My buddy just got the Baja Claws put on today. 35x12.50/17 on 6" Lift

 

[BIRDMAN]

That's what you get for Chinese ****... I wish everything was made in America... Very often I put things down in stores and refuse to buy them when i see MADE IN CHINA... USA all the way. (Pretty patriotic coming from a Canuck)

ehh i'm not that fired up about it. i can just replace the screws or take them out, sand them and clear coat them in the spring. i wouldn't blame KMC, the wheels have been wet and lathered in road salt for 4 months now

 

[shayneshow]

ehh i'm not that fired up about it. i can just replace the screws or take them out, sand them and clear coat them in the spring. i wouldn't blame KMC, the wheels have been wet and lathered in road salt for 4 months now

Just for the record that wasn't an attack at your wheels or KMC... I'm looking to order the exact same ones lol... That was just my personal frustration towards Chinese products in general.

 

[lacrosseman812]

hey is ther a way to get a part to make a tire with an offset below the stock tire to get equal with the stock tire?

 

[lacrosseman812]

Google Image Result for http://i.ebayimg.com/16/!B00j2fw!Wk~$(KGrHqZ,!jYE)pKuDO19BMc!i8(myg~~_35.JPG
what do yall think about these rims and what specs would u want to go with with these rims