ADD Bump Stop Kit for Gen 1 Raptors and SW performance connect under the rear bumper dual exhaust

[Big Papa Gecko]

still in here, 1120, so I don't actual work for a living...

I work as an AI doing ASME and other code work now, so I dont really do anything for a living either, hope you're in the good place over there though, shore tour is supposed to be better than sea duty haha

 

[bubblehead93]

lol, retire in a couple more years, so almost there... miss a little sea duty from time to time, family does not....

 

[Big Papa Gecko]

lol, retire in a couple more years, so almost there... miss a little sea duty from time to time, family does not....

The blue card is nice, all the perks, none of the duty.

 

[Anthony k]

The exhaust wrapped part will hold water and rot the pipe quickly. Better bet is a heat shield.

 

[bubblehead93]

so, its stainless steel, its sprayed with DEI water-proofing spray (not to protect the pipe but to keep the wrap from degrading)... run wrapped ss headers on my cobra for over 15 years... zero rot issues... looks as good as when i first wrapped it...

i do run some nifty carbon fiber heat shields for motorcycle exhausts where the piping runs under the trans pan (i have an aftermarket deep pan) and where it runs by my onboard air compressor... these provide an air gap between the multi-ply cf and insulator and the exhaust pipe... as well as the component I'm trying to protect...

I do agree if it was aluminized carbon steel like Flowmaster pipes/mufflers, the wrap would be a terrible idea...