GEN 2 2019 upholstery issue

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Beinkounter

Full Access Member
Joined
Aug 17, 2019
Posts
222
Reaction score
213
Location
Riverside, CA
The clips in the front of my seat cover on my 2019 have come undone twice, they are impossible to put back without taking the whole cover off. Took it to the dealership to have them fix it, they came undone again after a couple weeks. I probably need a completely new seat cover, just haven't had time to take it back in.

I have the same exact problem. Driver seat clips came off within a few days of getting my truck (2019 SCREW). After spending 3 minutes twisting my wrist in unusual ways to get them clipped back on, they came off again the next day. Will eventually take it to the dealer to fix.
 

Yoshi

Full Access Member
Joined
Aug 15, 2018
Posts
817
Reaction score
852
Location
Cornholio, MN
Mine had a small tear in the leather passenger seat at time of delivery. Dealer called in a leather guy, made it worse. Dealer refused to cover under warranty. Said I should go to another dealer. I was a bit upset. Gave them a bad review through Ford new purchase survey. They did not care. New seat cover is $500 retail. Could have resolved the entire thing. But no. Dealer sucked.
You can get whole takeoff sets on ebay for cheap if you still need them from vendors like shelby, roush, etc.
 

bigdave18629

Full Access Member
Joined
Nov 6, 2014
Posts
150
Reaction score
81
The clips in the front of my seat cover on my 2019 have come undone twice, they are impossible to put back without taking the whole cover off. Took it to the dealership to have them fix it, they came undone again after a couple weeks. I probably need a completely new seat cover, just haven't had time to take it back in.

Bringing up an old topic, but did you get this resolved? Any info on doing it yourself as my dealer is quite far away
 

Nibbl3s

Full Access Member
Joined
Aug 5, 2017
Posts
240
Reaction score
143
Same issue. Except passenger side. I will clip them in and they come undone. I plan on addressing with moon roof rattle

i have recaros

I have the same exact problem. Driver seat clips came off within a few days of getting my truck (2019 SCREW). After spending 3 minutes twisting my wrist in unusual ways to get them clipped back on, they came off again the next day. Will eventually take it to the dealer to fix.
 

bigdave18629

Full Access Member
Joined
Nov 6, 2014
Posts
150
Reaction score
81
Had this issue with my platinum too. Must be a common Ford issue. Would like to find a solution I can do at home. Just easier than getting to my dealer. Not recaro.
 

bigdave18629

Full Access Member
Joined
Nov 6, 2014
Posts
150
Reaction score
81
Yes, ended up going to the dealership and they replaced it with a new seat cover as the clips were broken.

Thanks, It looks like my clips are fine but can't seem to figure out how to attach them properly. I am assuming I might have to take the cushion out. Or, just plan a day trip and get the dealer to do it.
 

MattR

Full Access Member
Joined
Nov 24, 2019
Posts
885
Reaction score
521
Location
Houston, TX
The clips in the front of my seat cover on my 2019 have come undone twice, they are impossible to put back without taking the whole cover off. Took it to the dealership to have them fix it, they came undone again after a couple weeks. I probably need a completely new seat cover, just haven't had time to take it back in.

I had it happen quite a bit, it's frustrating. The dealer tried their "fix" over and over but it just slipped off again in two days.

I took self-tapping screws and stuck them through the clips. $0.50 and 20k later no issues
 

bigdave18629

Full Access Member
Joined
Nov 6, 2014
Posts
150
Reaction score
81
Call me slow....but I can't seem to figure out where the clips attach. I am a big guy (6' 7") so looking under the seat is a bit of a chore, but I thought it would be more obvious. It appears that you have to invert the hook somehow based on how it is hanging. Do you have to take the seat out, is there a way to just take the butt cushion off to do this. I have been searching from some type of assembly diagram but can't find one. Any help would be appreciated.
 
Top