gen 1

Hi everyone, just had a Stage 1 2.9l Whipple kit w/ custom (Non-Dyno but Datalogged) Tune installed on my Gen 1 SCAB. Been loads of fun at the low and high end but the mid range of throttle response has been troublesome (Video Attached). In the mid range of throttle it hesitates/cuts power and...

2014 Gen 1 Raptor -- having an issue trying to start. 1st start of the day, no problem -- but when I drive anywhere, park for a bit, then try to start, it will make a weird electrical-clicking sound then a minor "thump" that sounds like it comes from the undercarriage. Almost always starts on...

Howdy everyone, just recently purchased a gen 1 2012 raptor and I love the look of the round Kc hilites gravity pro6. Unfortunately I can't seem to find a mount for the gen 1. Kc hilites sells a mount but only for the gen 2. What are your suggestions/options? Would the gen 2 mount fit the gen 1?

Howdy Everyone, Finally ready to sell my 2013 Ford F150 SVT Raptor, 6.2L V8 super cab (2 door). Great condition mechanically; interior, and exterior in great shape as well. Tires have about 60% tread left 175700 miles on the odometer Vehicle is in Salt Lake City, Utah. One owner (carfax says 3...

Been in Utah for a few months now, got a new to me Gen 1 Race Red Screw with 76k miles. I plan to use this truck for everything it has. It crushed devils racetrack in the San Rafael swell and I’m ready for more(after I rebuild my shocks..). I have a full overland setup as well. Not sure who else...

Hello, so I found that my rear axles on my 2013 Ford raptor are bent. I don’t know how I even did it but I cannot figure out if they are 34 or 35 spline being that both say they are for my truck. in Other news I’ll be pulling the out this weeken does anyone have and tips on which 2 buy...

I have 5 used Gen 1 beadlock wheels. To be clear, these are the stock wheels with the fake beadlock rings. They are all fully functional, in decent condition, all with SVT center caps, and they all have the darker gray beadlock ring with red "SVT" because they came off my special edition raptor...

$275 Selling a pair of sidesteps from a 2014 Ford Raptor with 37k miles. The liner is peeling so that is why I am selling for cheap. I was quoted $175 to get them recoated at LineX. These side steps should fit all Ford F-150 Supercrew models within the year range 2010 - 2014. I can accept cash...

My weekend project was putting the LED blinkers in the front reflectors of my mirror, and the passenger side went off without any issues. Move on to the driver side, and I pulled the mirror glass off just like I did on the passenger side, but upon pulling it off I discovered that the whole...

Hi There - We have a 2011 Super Crew with 125k miles on it. The PS pump blew and I replaced the pump, belt, all pulleys and it blew another pump. I then replaced the rack and pinion plus new hoses all around.....and it blew the pump again after only 40 miles of driving. Truck has 35s on it and I...

Does anybody have Carr steps, or any similar single steps on their Gen 1? I’m looking for something other than the shin killing factory running boards. Would like to see some pictures if anybody has something. Google was of no help. Thank you, Luke.

I have a Gen 1, but I'm currently looking to sell it (https://atlanta.craigslist.org/nat/cto/d/alpharetta-2011-ford-150-svt-raptor/7511021679.html). I'm thinking about buying a Gen 2 after getting rid of my current one. However, (maybe I'm going crazy but) from browsing FRF I've noticed that Gen...

Has anyone found any videos of a SC Gen 1 racing a stock Gen 2? I think I saw one a while ago at Silver Lake but that was pretty unfair since the race was on sand.

For those of you who switched over to a Gen 2 from a Gen 1, did you notice any improvements in MPG? I know Ford lists Gen 1 as 11-14 and Gen 2 as 15-18, but those numbers seem a bit off from what I've gathered.

I'm having trouble locating these body mounts. I bought the ones for a '14 F150 and discovered they are not the same. Anyone else had this problem? I found a diagram and it doesn't appear to have a bottom rubber, yet it looks to me like it should. My son says it doesn't look like any rubber was...

Finally picked up a Raptor. It's been a dream of mine for a while, and the dream has finally come true. 2011 6.2L, SCREW, 191K on the dash. Work completed since I got it home - Changed all the fluids, plugs, O2 sensors, Fuse 27, UCA's, wheel bearings, amber lights in the grill, shorty...

Hey everyone. I plan this summer to spend some time and money to replace my rear leaf springs and possibly upgrade some other suspension components to improve the overall ride if possible. I had all four Fox factory shocks rebuilt in the past year, but I still feel every little bump in the road...

Came out of my 2010, they work fine besides seat heaters and that little bolster switch. I upgraded to slightly newer ones, no need for these now. $800 OBO for pair Located in Fort Worth TX, local pickup preferred. 817-709-93eight6

Hey, everyone. I bought my 2011 Screw back in December. Drove up from Georgia to North Carolina to pick it up. It had 4 previous owners and 114k miles, but it is in near impeccable condition cosmetically and pretty great mechanically as well. Previous owner was asking $35k, but I offered him...

WTB: Gen 1 stock front complete shocks. Will buy rear as well if needed to buy as a kit. Have to rebuild my ICON 3.0 front shocks and need the truck as a daily. Not many shops in BC Canada i know off can rebuild my Icons. Will pay shipping obviously or can pick up in upper washington if...

I have a 2011 6.2 with chronic radiator leak issues. I'll start by saying that this truck has never overheated that I am aware of and when I bought it, it had an OEM Motorcraft radiator in it. About 2 years ago I noticed a small coolant leak that was manifesting itself as puddles on the...

Looking to purchase a set of Geiser springs new or used maybe a user has a used or spare pair laying around they would like to donate? :)

Hoping for advice that is easy AND cheap (lol). Behind the rear seats, I had pulled the contoured material cover that goes over the rear wall, seatbelt mechanisms and window motor to pull wires for lights I installed in the rear bumper. I bumped the cable that goes from the motor to the window...

I’ve finally got all the parts sourced. If anybody is legitimately interested please let me know. I won’t ask for any payment until I have all the parts assembled and ready to ship to you. The top picture is the standard shifters. The bottom picture is the current ones I have. Other colors are...

I had the rear camera go out on my 2012 gen 1. I got the error message saying the camera wasn’t working see dealer. I noticed that the front camera then became disabled all the time, even in low or 2wd locked and off road mode. I replaced the rear camera with an aftermarket camera from TRQ...