Search results

  1. A

    GEN 2 OEM Bed Extender.... should I include in order or just get it after delivery?

    I have the OEM extender that I installed in my Raptor that I had in my 2016 Platinum. I had the factory Spray in bedliner and didn't have any issues. I did have to drill the bedliner material out of the grommet holes that the "pins" extend into top and bottom. I also have a Ford Rubber Bed Mat...
  2. A

    Cam Phaser/ Engine Failure Poll

    Mine is starting to rattle again 1500 miles and 2 months after having them replaced. Truck now has 31500 miles. Cam phasers issue, apim issue, camera in rearview mirror went out, and a leak because another ford dealer incorrectly did one of the recalls and failed popped an electrical grommet...
  3. A

    Cam Phaser/Engine Failure Reports

    I've always used the OEM filter on my vehicles just so there was never any finger pointing. My Uncle used to own a ford dealership and he told me many years ago that he had seen several engines ford replace at 70,80,90K miles because the owner could show the oil change history on it, and they...
  4. A

    Cam Phaser/Engine Failure Reports

    Dealer just closed out my paperwork from a few weeks back with the troubleshooting they did to allow for the Cam Phaser replacement. What was interesting was where in the checklist that it had a note to verify oil level, and verify that it has a Motorcraft Oil Filter on it.....Ive only put about...
  5. A

    Cam Phaser/Engine Failure Reports

    I had mine fixed last week and my 2017 had a build date of late June 2017. So I am guessing near the end of the 2017 run
  6. A

    Cam Phaser/Engine Failure Reports

    I bought my 2017 Raptor with 20K miles on it 3 months ago. In that 3 months, I have had the APIM replaced, the Mirror because the Auto Headlights did not work correctly, and I had the Cam Phasers, Tensioners, Timing Chain etc. Changed out this week. 3 Things I can be Thankful for. 1. I have an...
  7. A

    GEN 2 OEM Genuine Ford Parts Scalable Shock Security System Kit

    Good Idea. I had tried googling that part before and nothing came up. I searched around and found it shipped from another Vendor for $7.00 shipping. I had looked at several of the vendors I normally order from and they didn't carry it. I don't mind paying for the bracket, but just had a hard...
  8. A

    GEN 2 OEM Genuine Ford Parts Scalable Shock Security System Kit

    Does BajaMod ever offer any shipping discounts or sales? I was about to buy the bracket, but when I went to check out and it was almost $18 for UPS ground shipping, I stopped at that point and left it in my cart. That would put the cost of that bracket at $57.90 and I thought that was a little much
  9. A

    Battery dead after less than 2 years

    This is what Ford has yet to grasp. If you spend 70k or 80k on a truck, you would like the service to feel like that. I wish I could get the same service from Ford as I get from my Lexus dealer. But I know it will never happen despite the prices of the vehicles continuing to go up.
  10. A

    Rear Inner Fender Well Liners

    I put the Husky Liners on my 2017 Raptor. Probably one of the biggest pain in the ass projects I have done on any vehicle. I've restored several vehicles as well as do my own paint and bodywork, rebuild engines, etc. I got them installed in about 2 hours leaving the tires on the truck, but I...
  11. A

    Bakflip MX4 - Improved Drain Tubes

    OK, Picture attached. I checked this morning after a night of rain and it was not wet. I cant decide if I want to add some drain tube to put it a little further into the hole, but right now, the elbow goes in about 1/4" -1/2" inside. I looked at my receipt and each of the Irrigation T-'s were...
  12. A

    Touch Up Coating for Side Steps/Running Boards?

    I had a 6" scrape on the bottom of my 17 raptor when I bought it a few months back. I bought a can of rustoleum bed liner spray from O'Reilly auto parts and ended up staying it onto a piece of cardboard and taking a small touch up artist paintbrush and painting the scrape. You would never know...
  13. A

    Bakflip MX4 - Improved Drain Tubes

    Awesome idea. I did not even know those holes were there. I bought my 2017 raptor used a few months ago and it already had an mx4 on it when I bought it but no drain tubes hooked up. I ended up buying 2 irrigation 1/2 inch elbows. They were threaded on one end and barbed on the other. I reamed...

Members online

Forum statistics

Threads
95,309
Posts
2,004,479
Members
58,825
Latest member
AB37P
Top