Search results

Remove existing nuts leaving bolts in place...install new adjustment plate, then install new "nut", tighten, then have aligned.

Did mine in my driveway, one at a time then drove it to get an alignment. Took all of 20 minutes.

Jumped on the band wagon....ordered via website. Dan06.....Just the thing for baja! :crazy:

Thanks Chris for bringing Tysen to our attention! I'm in, x20!

V8......Bigger is always better!!!!

Weekend Mods Finally had a free weekend to install some mods that have been sitting in the garage......... Installed the RPG UMP filter kit. This is the ONLY CAI filter to use if doing any off road driving, especially if traveling down in Baja! Installed the HDC HD Battery...

Yep, heard the same thing from my dealer........

Great Deal! Have a similar setup, works great!

New Wrap! The Matte Charcoal wrap I had was looking kind of tattered, so I decided to have it redone......initially chose a matte dark blue, but after removing the original wrap, the stock color, black looked sooo good, decided to go with a gloss color that wont show "pinstrips" from the bushes...

Got It! Thanks!

Have read both of your headlight build threads and I didn't see where you mentioned how you sealed/reinstalled the lens.

Im in for a set!

Thanks Kaiser!

I have four freshly powder coated Blue Flame SVT center caps for Method wheels. Will sell for what I paid for them....$205 + shipping Bolts NOT included!!

I run 37" BFG Projects, with no problems!

There is an inner seal that is holding the oil in......the seal in the cap is more of a wiper. Having said that, I would remove the spring ASAP and screw the cap on before it gets damaged

Thanks Kaiser!

Used RPG PS reservoir, Black with Derale 24" cooler. All fittings and lines included. $300 + shipping. ***SOLD***

Buddy of mine has this setup on his Border Task Force Raptor undercover truck!!! Sorry....No Pics!!

While prepping for a new wrap, pulled down the head liner to removing the radio and GPS antennas, I fixed the latches for the rear seat backs, adding a small pull to release them.....there is a fair amount of room behind the seats for gear. Have to finalize the wrap color...

2011 #10054 -- SanoDano -- Tuxedo Black -- SCrew

Didn't have any problems with fittings, etc.......I found this diagram to be helpful, http://sdhqoffroad.com/wp-content/uploads/2016/03/raptordiagram.pdf & http://sdhqoffroad.com/wp-content/uploads/2016/03/bleed-instr-1.pdf

Wasn't too hard to install the Howe PS kit......most difficult part was removing the stock PS pump. Used the DIY thread from justcozz & Trapcity as a guide. http://www.fordraptorforum.com/f170/ps-pump-change-diy-courtesy-%40justcozz-i-46964/#post962272

Yes, fits better then the stocker...... Bosch Platinum Series AGM Battery Group Size 65 https://www.pepboys.com/product/details/838869/00701/2011/FORD/F150%2520PICKUP/0/V8-6210%25206.2L%2520SOHC

Been there, Done that!!!! :ROFLJest::ROFLJest::ROFLJest: The Check Engine Light will go out after a few minutes of driving!