Truck looks awesome….I’m interested in what you had done for your truck. Can you tell me how did you ask them to get this done? I’ve looked through their website and there is nothing for an option with a topographical design. Thank in advance.
For those that would like to use the FP Oil separator for a Gen 2 on a Gen 3; the system will work and install in the same general area with minor modifications.
Using the idea from “Redsmoke’s” post I did my own test trial an figured a way to install it. Take a look at the pictures below and...
I personally go for the silver one because I have a silver one just like it lol and black only stays clean from the car wash to the house.
If I was to make an offer I give them 67K for the silver and re-sell the canopy of you don’t care for it, those things are expensive.
The black one only...
If you are having issues with the trim on the truck in areas like the lower grill, bed rails, hood, etc, etc.
Just take it to your dealer and they will replace them under the warranty. It might take a few days or weeks depending on what they have in their shelves.
Mine started to fade off...
It might be easier to fallow the wires and find where the O2 sensor plugs in. Disconnect it there and take that section of exhaust off the truck so you can work on it.
I learned my lesson several years ago with my E46 M3 (black). You don’t know how bad was the vehicle before you and those brushes collect a ton of debris. Since then I use the DIY wash drive home fast enough to remove most of the water and then proceed to detail the truck. Ive also tried the...
The steering wheel in our trucks seemed to have an on going issue with the quality of the materials used to construct this things. Mine has signs of discoloration around the red leather strip and it has only 8k miles. The dealer will replace the whole steering wheel if it is under warranty...
Sorry I wish I could help more. I was reading through the FAQs in the link above I figured I post it. Look in there and see if your problem is similar. They might have the answer
I got mine today and I had to hunt down an old PC to run the software updates. But unfortunately the pc needed updating to and then got busy. I’ll post my experience with it when I get it all hooked up. Did you run the updateds on it before you try to install it on your truck?
Just want it to thank Richnot for posting the give away link. I got an email yesterday confirming that I was one of the lucky winners. Thank you again...I’ll make some time to post a review of it after I get familiar with it.
I’ve been following this guys since they started about 3 years ago. The F150 was covered already but I always felt that the Raptor could off had its own episode. Thank you James The Pumph ... lightning, lightning, lightning.
I’m sorry that happened to your Raptor. For sure people are telling you “is very small you can’t even see it” but you can and that’s going to bother you for a long time. If I was you, I would try @RAPPYgraphics they do some very nice decals for our trucks. eBay has some good selections too for a...
I had the same concern with this shifter lights. For the 19 Raptors the actual words on the shifter console are painted on and even if you buy that light and installed it, you won’t be able to see the lights. I’m not sure for 17 and 18 years. Best of luck
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.