Search results

Put some safety wire or device on those shackles, really sucks to be the guy behind you when you loose one at 80 on the highway!

Give Keith at LVJ Motorsports to get sorted out with antennas and mounts http://lvjmotorsports.com As for your radio, you are going to have to do the TX band mod to make it work on GMURs and business band frequencies: Icom ID-4100 modification wide band TX by Marcus PA2DB

So I'm planning on pulling my WSI HD leaf pack from the truck this weekend and repainting them. I figured that while they where off the truck I should replace the bushings as well. Does anyone know the sizes for the bushings? And the specs for the u-bolts?

There is someone retrofitting these to Gen2 lights, it was posted in facebook a while ago.

Finally got around to rebuilding the Icon Zeta 3.0's that I took off my truck to rebuild over 6 months ago.

Here is a rendering with a Baja Designs RTL mounted: This puts the bottom of the RTL just under 7" above the bed side caps.

That is the SVC tower, I don't know if the have a gen 2 version yet.

Yes bolts straight through the sheet metal, you could recess it in the bed cap by cutting a hole in the cap if you wanted to, not necessary however. They just clip on, small tabs on the underside of the bed cap on the inside of the bed, work you way down unclipping them all and then just...

Rebuilt a set of Icon RXT rear shocks for my truck, i've had stock shocks on the back for far too long now.

If there is interest it can be done, probably with options for pods (S2's) or the RTL light, optional antenna mount bracket.

Guessing this is for a street queen, these steps don't do well when taken off-road.

Humm perhaps you should have read the sticky at the top of this section before posting........ http://www.fordraptorforum.com/f12/your-raptors-audio-system-37480/

Speaking of supporting vendor, it would be really nice if the admin's actually responded to requests about info for becoming one... just saying...

Any reason your going with Icon over deaver?

Yep should take you less than an hour. Take your time, double check the cable, there are 2 blue/red wires in there.

GJ Motorsports just got exchange shocks back in stock. http://facebook.com/gjmotorsports

Doesn’t matter too much, extra current will be drawn from the battery if the alternator can’t provide it all. However to be safe you should probably makes sure you have a agm or deep cycle battery installed. Lots of people run winches that draw 200-300 amp when running without issue.

Not today but last week finally installed the fuse 27 relocation kit after it burnt out on me, kits been sat under the rear seat for 2 years.

FYI: https://www.facebook.com/gjmotorsports/posts/136794643608760

Gen 1 Roll-x $100 Chase light rack with 2 amber totron cubes - $100 Gusseted knuckles (gen 1) - $500

Looks well machined. I'd still like to see a snap ring or spiralock (what IVD uses) to make sure the bearing stays in the correct position.

I did the work, no guarantee or warranty other then they will be shipped in good condition, no cracks and arrive in the same condition. I’ve done half dozen or more sets of these now including for Jimbo, Kmandoske, BigBlue, fingermalone, 2 sets for my truck and a few others not on here. The...

Cut out a bed bolt that the nut had stripped out of the retaining plate on and then replaced all 4 of the front bolts and captive nuts.

There is a reason you can't post in the garage sale section yet, pay up or contribute to be able to sell here.

Nothing that the dealership fails to do should surprise you! Buddy of mine took delivery of a Focus RS that had the shipping spring lift blocks left installed by the dealer that give it enough ground clearance to get on and off the train/trucks.