Search results

My needle is mounted into a regular valve with a brass fitting, the valve is then screwed into the lossless air chuck

Scab or screw?

this code is thrown when there is a short to ground in the valve so either a failed valve (burnt out winding) or a short in the harness

doubtful, this is fuel tank emissions control, unless you trashed a harness with your supercharger install.

Also check the wiring harness running along the drivers side frame rail for damage.

There is a speaker jack on the back that you could attach to a PA however this only outputs received transmissions. Not sure anything out there will allow you to use the radio mic for a PA mic.

NE Ford

Search for the clunk thread

Got these the other day, used them to remove the water spots from the rain last night. Thanks! Oh if you still have that gallon let me know!

I think you spelt taint wrong.

It was worth a try!

You should send me a demo unit to put on my truck for the Midwest people to see!

Used it to pick up a gantry crane from auction towing within the raptors limits :crazy:

Every one of these I see is slightly different, guess they are still working out the kinks. Love mine!

Sitdown

A tongue weight of 960lbs leaves you with 60-80lbs for you, anything you added (bumpers lights winches etc), the trucks fuel, any passengers etc. This trailer is over weight for your truck. Tongue weight is included in the payload rating. This is another reason for the low rating.

Ford Raptor Towing Information

0, none, nill, zippity squat! You can't increase the trucks capacity above the manufacturer's ratings without legal and liability issues.

Don't think I've seen a raptor without ac. Sure it's not a conversion?

Mine was the front leaf mount bolt, suck a go pro to the top of the leaf spring and drove around a spot that would make it so its thing until I narrowed it down, a role of 3m moulting tape helps so you can just stick it to something drive pull it off move it stick it some where else and repeat.

Why did you go and do that?

Here you go Painting tail lights or maybe this one DIY Painted Edges on Taillights

Yes search is your friend!

Can second the slippery comment, did mine and fell out the truck immediately afterwards!

I have some spots but much larger towards the front of my running boards, some vrt made them much less noticeable.