Recent content by BBLV

Yes, the two outside “wings” that house the fog lights unbolt from the silver middle section and there are three separate plastic inserts that clip onto the front of the silver section as well. There’s an upper rubber gasket that unclips from the silver and stays connected to the outer black...

I find it curious that the new dual live valve shocks on the 2024 37 & R have uncoated solenoids with immediate corrosion (from every source and photo that I've seen of production trucks, including my own 37), but the non-dual live valve solenoids (on 2024 and previous Gen 3's) are anodized...

Only problem was the parking sensor error popop at startup (and some weird looks at stoplights with my bumper missing).

Haven’t put the springs on yet - I need new wheels first or the lift will look funny IMO. It took a couple hours to figure out how to get the bumper off and disassemble the silver portion. Lots of screws and clips… but nothing too bad. Just took pics along the way that I could refer back to if...

Powdercoated front bumper and skid plate satin black, chopped factory antenna by 4.5” for a parking garage feeler, installed a BAK Revolver X4S bed cover, and tinted front windows 20% and windshield 65%.

Pulling the bumper took longer than expected, an extra set of hands would’ve helped to unplug the wiring harnesses while holding the weight of the bumper. Harder taking it off than putting it back on, but 100% worth it. I lightly sanded the parking sensors and hit them with some satin black...

Picked up my SG 24 37 about 2 weeks ago. Just pulled the silver bumper and had it powdercoated satin black along with the skid plate. Had a set of Eibach springs powdercoated satin black at the same time. Need to get a new set of Innov8 beadlocks ordered now.

Just pulled mine and had it powdercoated satin black along with the skid plate. I also welded the license plate holes closed, but the powdercoater misunderstood what I meant by smoothing out the welds…

The orange ano surface wipes clean with a damp rag. The uncoated surface not so much - corrosion kicked in on day 1.

It’s obvious that they ****** up and somehow these parts got through QC without ano. Here’s my 37 with 27 miles on it when picked up last week. I live by the ocean and these solenoids are going to crumble apart if uncoated for several years…

Checkout this thread on FB addressing this corrosion: https://www.facebook.com/groups/3238750906269171/permalink/3271672686310326/?mibextid=W9rl1R

Referring to the aftermarket Eibach springs…

Has anyone cut some off the back spring so it only gives +/-0.5-0.75” of lift? I want to do front 2.2” springs on my 24 37, but want front and rear spring rates to match. IMO the rear 1.5” spring lifts it up too high - just doesn’t look right to me.

They completely f’d us with these ugly 2024 37 wheels. The wheels shown in the build configurator up until a few weeks ago actually looked good - I wonder why they pulled a last minute change for the worse?