Recent content by Andrews

1. Yea you could absolutely have HSW control on the display. The only way to do it from what I understand on the Gen3 Raptor is Unreal mode on the display and add the climate controls on the bottom. Here is a picture of it set up on my truck when I was playing around before getting the parts...

Sounds great I’ll help anyway I can!

My 23 was built in late November. If you remove the airbag you can see if your wheel has the heating element pretty quickly.

Alright guys install is done! Works like it should have from the factory. Tried to make a video to show what I thought would have been helpful for me to see going into this. I’m not the best filmmaker but if you guys have any questions feel free to ask! Boosted grey goose also send some...

My 23 came with the heated wheel installed 500 and I’ll be set hope yours is the same.

I’m into it right now I’ll make a few videos for you guys

I actually get parts in today! Was planning on posing an update after the install. From digging around in the truck I know I need the clockspring since mine is blanked out behind the steering heat plug and I want the hard button on the HVAC Module not screen control. (Want to keep it Factory) I...

Alright! through some help thanks BarryT82 found the ClockSpring just has blanks. Going to order a new one and will let you all know how the install goes!

Just checked the harness going into the BCM slot 15 has a blue/ orange stripe wire running into it.

Looks like after the update that option isn’t in the APIM not sure if there is a way to do it in the APIM As Built but in the options for vehicle type the closest option is F Series. Haven’t tried that but Superduty isn’t there. I’m going to pull the bottom cover off the wheel assembly and...

From what I can tell after putting it on my display it looks like the Lightning display. Has the HVAC controls permanently on the bottom of the screen much different UI setup than the normal f150 or superduty.

Picture was taken through the hole in the bottom cover of the steering assembly.

Here is a picture off the back of the SCCM looks like I have the WPT harnesses? Or is that the back of the ClockSpring not sure. Can you verify that? I’m wondering if I just enable it properly through FORScan it will work… tired earlier I turned on steering wheel heat in the SCCM 724-01-01. but...

I just took the airbag off my 23 Raptor (Heated steering wheel removed/ No hard button) and from what I can see I believe I have the heating element and correct clockspring??? Video attached if that is correct how can I verify that and the harness? could this just be a simple Forscan mod for me?

Is there any way you could get a picture from the rear door looking across the back seat? yours definitely looks recessed though... the top of mine sticks out.