Hey everyone. Have any of the guys with Gen2 Raptors upgraded wheels and tires yet? I have a set of ADV.1 wheels I am taking off my Gen1. I am trying to figure out if 35x12.5x20 tires mounted to a 20x10 wheel with a zero offset with cause any rubbing issues?? I am running Nitto M/T tires. I know from the threads all the talk about there being no perch adjustment. Just trying to see if theses wheels will fit the "stock" suspension.
GEN 2 Zero Offset Wheels
- Thread starter CWBROWN
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
17Jake
REBEL 12 HK
plenty of clearance
inner +15
outer +53
#go wide
inner +15
outer +53
#go wide
Last edited:
Check the Gen 2 exterior forum. There's a thread on aftermarket wheels there. [emoji1417]
Bill A
Member
Think it's 34
BBLV
Full Access Member
Stockers are 8.5" wide and +34 offset.
JetDriver480
FRF Addict
- Joined
- Feb 5, 2017
- Posts
- 1,040
- Reaction score
- 701
I know a bunch of people running a +1 offset (same as 0 basically) with no issues. I will be running 9" wide wheels with a +1 offset also. No problemo.
Sid-X
Member
- Joined
- Dec 17, 2010
- Posts
- 47
- Reaction score
- 19
Something to consider. I went from stock offset to 0 offset Method Standards on my G1. I often drove my truck hard off-road and never had any rubbing but my first run on gravely BLM roads I came home with ton of rock chips because they stuck out like an inch farther. My black paint looked like a star field in one run. I went with XD RG1s on my G1 which are closer to stock offset at 25. You may consider some paint protection like XPel or mud guards I you are worried about chips at all.
Kong Newton
Member
Hello all. I'm in the same boat. Have a 18' gen 2 looking to put 20" wheels. Can any give me some good suggestions on offset and will 35x12.5x20 cause rubbing? Thank you
Similar threads
