Reply to thread

I cleaned out and lubed all the uniballs and heim joints on the front end. I used CCR Power Lube with PTFE to coat all the joints after cleaning all the grim out. I know a built front end will never be quite like OEM, but it sure is much quieter and smoother now.

I took those swapbay adapters off and cut a 1" hose I had laying around in half about 1.5" long and installed on top of the swaybay, slid the adapters back on over the runber and tighten it all back down. No more clanking as the rubber hose filled in the gaps on the adapters.

I loosened the Borla Atak exhaust system as it seem to have small exhaust leaks at every connection point (black soot) cleaned everything up and reinstalled all the pipes and tighten everything back down. I can't hear any leaks now.

Checked and blew out the rear axle vent tube hose. I could barely blow through it before I blew it out with compressed air. Now it's free flowing.

I need to replace the lug nuts as they have surface rust and look to be OEM. Any suggestions for replacements other than Gorillas?