Reply to thread

Message: <blockquote data-quote="gwpfan" data-source="post: 1271744" data-attributes="member: 14481">Wasn't today, but been busy.  Added a front receiver.  Went to a weld shop and had this modified - <a href="https://www.curtmfg.com/part/31068" target="_blank">https://www.curtmfg.com/part/31068</a>  Using it as is it set way too low and reduced clearance and I would've had to take off/modify my skid plates.Pretty happy with the results.  All bolt on and only cutting was that of the front grill for the receiver to go thru.Only thing I would've done different - Receiver pin sits out front of truck.  Should've made a hole deeper in under hood so license plate can't be easily pulled.  One would then have to go under truck/open hood to pull receiver pin.  Fixed the issue by getting a locking pin.  Also license plate doesn't sit out that far, pin was removed and it pulled slightly out.  Will see if I have another pic...Update - didn't so got one.[ATTACH=full]100279[/ATTACH][ATTACH=full]100280[/ATTACH][ATTACH=full]100281[/ATTACH][ATTACH=full]100282[/ATTACH][ATTACH=full]100283[/ATTACH][ATTACH=full]100284[/ATTACH]</blockquote>