What did u do to your raptor today?

[Irregular F150]

Finally had time to put the gj ps cooler on. May give up on the chase bay res though, it’s turning out to be a pita lol.

 

[Jakenbake]

Finally had time to put the gj ps cooler on. May give up on the chase bay res though, it’s turning out to be a pita lol.

Chase bay?

 

[Irregular F150]

Chase bay?

Its a universal one. They make nice stuff but mostly for drift/race cars

 

[WNCHSTR96]

Its a universal one. They make nice stuff but mostly for drift/race cars

Yikes I’m not sure what’s worse, the pinched line on the missing clamp? I’m sure this photo was work in progress and that you don’t drive it like that?

 

[Dudebrodude]

Yikes I’m not sure what’s worse, the pinched line on the missing clamp? I’m sure this photo was work in progress and that you don’t drive it like that?

Haha I think he did that just so fluid wouldn’t leak out while he’s figuring out placement/mounting. Otherwise, this reservoir would be just for show.

 

[Irregular F150]

Yikes I’m not sure what’s worse, the pinched line on the missing clamp? I’m sure this photo was work in progress and that you don’t drive it like that?

Haha I think he did that just so fluid wouldn’t leak out while he’s figuring out placement/mounting. Otherwise, this reservoir would be just for show.

LOL

Yeah its empty and mounted just to figure out the setup, i put the hose on it cause i had to run in town and didnt want any dust etc to get in it. It’s currently not mounted..

 

[dj30417]

Had radiator flushed and overflow reservoir repaired. Also, replaced rad cap. Bumper still being debated.

 

[TomDirt]

It's easier to insert the axle into the hub if you slide the IWE over the axle first, then stuff the axle,(after lubing it up) into the hub. No jumping on the LCA to get the little 1/2" threaded end past the IWE cup.

 

[Cody Templeton]

SVT decal from the good folks at nicedecal.com. It occurred to me that there is nothing very obvious in the cab that indicates that a GEN1 is the product of the Special Vehicle Team. This takes care of that. The Nice Decal folks were kind enough to make a decal that is considerably smaller than their usual. No extra charge and no shipping charge.

Aux switches and cluster! Also, if you have the Weathertech mats they make decals that replace the Weathertech ones that say SVT.

 

[Jakenbake]

Set the rears at 150psi, checked the limit straps, did a little measuring, etc.

It is always fun fully drooping the rear out on the sloped driveway….