Reply to thread

Message: <blockquote data-quote="ImAllSCREWdUp" data-source="post: 1852291" data-attributes="member: 47073">Stripped the torx on the front two bolts, had my metal shop weld large nuts on the heads and broke free easily. They were rusted into the welded nuts below.The middle bolts are spinning, the stupid clip-washers broke (see image). Bought a thin 18mm wrench and it wont fit latterally in the frame slot - even after thinning the wrench further and removing material from the width of the wrench. Gonna try again tomorrow, what a pain.Planning on having the middle replacement nuts welded in place by the same metal shop.Any thoughts on welding the new middle nuts in place?</blockquote>

Total: 2,454 (members: 29, guests: 2,425)