Ford released a new update a few days ago. Just found it on the MyFord site, downloaded it to a USB drive, and spent about 30mins letting it install. TBD on whether or not it fixes it, but I have my fingers crossed!
SYNC 3 PROMPT
- Thread starter K9 EXPERT
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
The USB drive must be formatted as exFAT and then all I did was copy over the files to it, plug it into a USB port in the truck, turn on the ignition, and then after 30-45s the “installing system update” banner appeared at the top of the screen. It then stayed like that for about 30-40 mins (while leaving the truck at idle) before restarting, going back into the installing system update status and then finally it said to remove the USB.
Just finished the install and can say that the prompt no longer pops up! Still need to take it for a drive to see if it gets stuck on reverse screen, forget WiFi, etc.
Edit: can confirm the update fixed all the issues for my truck
Last edited:
OEMPlus Raptor
OEM preferred....
YESSS!!! Downloading now. That prompt was driving me nuts
Update: It worked for me. Downloaded on USB flash drive and followed steps as show on website. All in all took about 10-15 minutes.
Update: It worked for me. Downloaded on USB flash drive and followed steps as show on website. All in all took about 10-15 minutes.
Last edited:
Any links to this update? Thank you!
Are you using a Mac?
Windows 11 on my surface.....used it to update it to 3.4 from 3.0 b4 it started causing all of the freezing problems now.
