Reply to thread

I just did the same install with the ridgid radiance w/out the flasher and I didn't purchase the harness either. The up lifter switches  already have fuses.  So coming out of the fogs are 3 wires (white/red/black).  White is for the amber backlight. You can tie each one of those together, I put the 3 whites on the passenger together and 3 whites on the drivers side together. I ran each side off of the marker light on the fender flare on the front of the truck. You can get to it threw the wheel well, 2 screws and pull back the liner. You want to tap into the yellow wire coming off the back of the marker light.  Black wire I tied all 3 togeather on each side and grounded it to the frame.  Red wire, since you want the 2 inside cubes and 4 outside cubes wired to there own switch,  run the red wire off of the 2 inside cubes to the  green/blue wire (Switch1).  Tie the red wire coming off the 2 outside cubes togeather and run that wire to the gray/yellow (switch2).  The Aux power circuits are found  as blunt cut sealed wires located by the power distribution box on the passenger side.  Hope I help, good luck. It isn't hard at all once you get into it.