Reply to thread

Message: <blockquote data-quote="WishIWasARaptor" data-source="post: 2107316" data-attributes="member: 74238">In regards to user over tightening, you might try a compression test by just printing a flat and seeing how much torque you can apply to it before cracking. Depending on your infill value you might be surprised at what you can achieve. The other option would be to increase the wall thickness to accommodate compression. I've cranked up infill to 80-90 percent for items that were going to carry a load and with just standard PLA you can get super aggressive.Appreciate the offer for a set, I currently don't have a Raptor and am just lurking until I hope to get one later this year.</blockquote>

Total: 1,229 (members: 20, guests: 1,209)