GEN 1 JDM Roush Upgrade kit (675/700hp)

[Dane]

you have the 69mm upper? I have the belt number you need for the 69mm upper and that lower. I will find it and send to you.

Yes, 69mm VMP upper.

 

[Canuck714]

I think you guys run the Gates K061247

 

[Dane]

I think you guys run the Gates K061247

As is, yes. But not sure about with the larger lower.

 

[Canuck714]

I am running the K061251 belt. But thats for a Phase II, 75mm and stock bottom

 

[MTF]

There's a 7/16 difference in length between the two.
That last four numbers is the length in inches. 124.7 and 125.1
I can run either one on the Whipple. Stock harmonic balancer pulley.

 

[Canuck714]

^^ Same @MTF
I think Dane has a 72 top and larger bottom so I dont know if the 124.7 will fit his application

 

[Dane]

^^ Same @MTF
I think Dane has a 72 top and larger bottom so I dont know if the 124.7 will fit his application

No, I have a 69mm top and stock bottom. (My larger bottom is still sitting on my shelf collecting dust)

 

[Canuck714]

No, I have a 69mm top and stock bottom. (My larger bottom is still sitting on my shelf collecting dust)

Ahhhh... then I just filled this thread with belts that dont work for you...lol

 

[Dane]

Ahhhh... then I just filled this thread with belts that dont work for you...lol

Well, I'm currently USING K061247...
What I don't know is if I'd need to change it for the larger lower.

I suspect I'd at least want to change to the K061251. Mine's already a tight fit, but it would be nice to confirm the belt for a 69mm upper with 10% bigger lower.

Also - THREAD HIJACK!! YEAH!

 

[B E N]

Are you serving at Fort Carson? They have a decent auto shop you can work at if so.

Heat exchanger would be high on my list, heat soak sucks. Headers would be second.