Reply to thread

Message: <blockquote data-quote="RRitch" data-source="post: 1913496" data-attributes="member: 65885">I have seen quite a few videos about different methods to install aftermarket tweeters to replace the factory tweeters in the A-pillars.  I went with a set of JBL club series speakers That were the same diameter as the factory.  When I started trying to figure out some sort of bracket to mount them, I started to think that IF I could figure out how to get the original tweeters out of the factory bracket that the JBL might fit into it.   Turns out I was right.  It was not very difficult to get them out, but it will destroy them factory tweeters so they will not be able to be reused.  Once I get them out, there was a small ridge inside the ring that I had to file away, but once that was gone, the JBL pressed into the bracket and fit perfect.  After that I just used a little foam tape around the perimeter of the tweeter to help steel it against the grill. Here are a few pictures to show how they fit in the bracket and with them mounted.[ATTACH=full]409995[/ATTACH][ATTACH=full]409996[/ATTACH][ATTACH=full]409997[/ATTACH][ATTACH=full]409998[/ATTACH]</blockquote>