Gen 3 LP4 light issue

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

MNLeadfoot

Active Member
Joined
Oct 28, 2018
Posts
54
Reaction score
41
Location
MN
Hey guys I apologize in advance I'm working on limited electrical experience but I'm learning! I mounted some LP4's up on the a pillars and they worked great for about a year. My issue that I'm having is one night I pulled into the garage and noticed the side leds were flickering, not the main spots just the sides. Switch was not on and continued to flicker after truck was off. Didn't have time to dive in to it and noticed some water had dripped down on to the relay so I pulled the relay and left it at that. I tested the relay and according to the test the relay was fine? Checked all fuses and everything is fine? Plug the relay back in and nothing? Forgive my ignorance but I am learning and need some direction!
 

So-Cal-Al-52

I Love Fossil Fuel
Joined
Jan 21, 2022
Posts
731
Reaction score
1,226
Location
San Diego
I am not really sure what would cause that, I have LP4's on my A pillar but I didn't use a relay, I went straight to Aux 2 (15 Amp). I tapped my backlight into the DRL's. So it sounds like we wired up differently. I wonder if it has to do with the relay?
 

smurfslayer

Be vewwy, vewwy quiet. We’re hunting sasquatch77
Joined
Dec 16, 2016
Posts
17,505
Reaction score
26,927
I don’t think the side lights have a separate circuit, but that does sound like a relay issue. Look for water intrusion in the relay
 
OP
OP
MNLeadfoot

MNLeadfoot

Active Member
Joined
Oct 28, 2018
Posts
54
Reaction score
41
Location
MN
I don’t think the side lights have a separate circuit, but that does sound like a relay issue. Look for water intrusion in the relay
Ya I thought it was odd that only the side led's were flickering. I'm hoping the lights didn't take a crap bit we will see.
 

ToadSmasher2K1

Home Is Where You Make It
Supporting Member
Joined
Jun 27, 2015
Posts
3,458
Reaction score
9,509
Location
KC
I had a similar issue with my BD Onx6. Smurf and car stereo guy helped me determine it was how I had the relay mounted that was allowing water to get in.

Most relays need to be mounted vertical, with the wires coming out of the bottom to keep water from getting in. I switched mine from horizontal to vertical and haven’t had a problem since.

Mine was starting to melt also, so might check that as well. I had to get a new harness


IMG_3840.jpeg
 
Top