Cobb FMIC installed. Lost reverse brake assist

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

braaptor37

Active Member
Joined
Mar 22, 2022
Posts
52
Reaction score
55
Location
Florida
Hello I installed a Cobb front mount intercooler and now my truck says reverse brake assist not available!

Any suggestions? It worked before I messed with it lol
 

Antho

FRF Addict
Joined
Apr 12, 2019
Posts
2,015
Reaction score
2,585
Location
Texas
How long have you been driving since you did the intercooler? Assuming you disconnected the battery? The system has to relearn steering center before it will work. So it may need a drive before it will start working. This is all assuming you havent been driving since the intercooler swap.
 
OP
OP
B

braaptor37

Active Member
Joined
Mar 22, 2022
Posts
52
Reaction score
55
Location
Florida
How long have you been driving since you did the intercooler? Assuming you disconnected the battery? The system has to relearn steering center before it will work. So it may need a drive before it will start working. This is all assuming you havent been driving since the intercooler swap.
Did not disconnect battery, didn’t see that part in the instructions.
Drove 2 key cycles maybe 15 mile round trip.

Also the piping was a pia. Do you know the correct way the driver side goes? can’t figure that out either
 

hingedthinker

Full Access Member
Joined
Nov 23, 2019
Posts
548
Reaction score
970
Location
Phoenix
look up my thread and pics of the install. The driver side pipe was a pain, but only until I realized you needed to balance the overlap to make it work with the pipe clamps
 

ToadSmasher2K1

Home Is Where You Make It
Supporting Member
Joined
Jun 27, 2015
Posts
3,496
Reaction score
9,641
Location
KC
The rear brake assist is turned on and off through the vehicle settings on the main screen. It might be as simple as turning it back on?

I have mine turned off because it freaks out when I’m trying to back into my garage.
 
OP
OP
B

braaptor37

Active Member
Joined
Mar 22, 2022
Posts
52
Reaction score
55
Location
Florida
The rear brake assist is turned on and off through the vehicle settings on the main screen. It might be as simple as turning it back on?

I have mine turned off because it freaks out when I’m trying to back into my garage.
I don’t see it on settings?
 
Top