Reply to thread

Left:

[ATTACH=full]270571[/ATTACH]

Left:

[ATTACH=full]270572[/ATTACH]

Center:

[ATTACH=full]270573[/ATTACH]

Center w/low beams:

[ATTACH=full]270574[/ATTACH]

Center w/ high beams:

[ATTACH=full]270575[/ATTACH]

All pics taken at dusk.  The lights are likely brighter than both low ans high beams, but the light is "diffused" and spreads quikly.  If you look right at them in the dark they are blinding; 5600 lumens per lamp is a ton! (Well more than 5 tons)

The brackets arent too hard to make.  1.5" aluminum angle about 14" long.  Drill two hole that line up with factory bumper bracing holes.  The clips on the factory bolts can be tricky to remove.  You will need to buy a nut for the larger bumper bolt and i bought stainless hardware (nuts bolts washers) to mount.  Cant remember the exact sizes but they were the sized to fit through factory holes.

I took a while to make mine, but Im pretty **** about fot and finish.  It took longer to develop a plan than to cut and drill the angle.  Depends on you level of skill and experience work with no directions or exact plan.