Search results

Are you sure those are the right type lug nut? They look like cone seat lug nuts. What you want are cone seat bulge style lug nuts. Bulge lug nuts have an extended seating surface that is designed to match the wider seating surface used on some aluminum wheels.

https://www.fcsdchemicalsandlubricants.com/resources/quickreferencecharts The third pdf explains this.

Number one suspect is a squirrel.

Here is the link to the previous Breckenridge trail thread: https://www.fordraptorforum.com/threads/breckenridge-co-trail-suggestions.85022/#post-1649632 Still lots of snow in the passes. The tunnel near the top of Rollins pass has been collapsed for a long time. If you stay in Breckenridge...

Instructions say to remove fuse 27 from the holder. Also to place heat shrink around the cut off end that goes to fuse 27 holder. You should be able to pull the red/blue out of the way and solder and heat shrink to the wire provided in the kit. Use a piece of aluminum foil to protect other...

With the newer versions of Forscan you do not need the spreadsheet values to make common changes. You just select what you want. Then flash. Here is what tire pressure settings look like: Also you can't go wrong with the obd link adapter recommended by Forscan from amazon...

I think that your radiator drain or radiator may be partially blocked. When I drain my 2014 I get about 6 to 8 quarts including what is in the overflow tank. When I drain I leave the radiator cap on. This will siphon out the overflow tank. When the overflow tank is almost empty put a hose pinch...

Here is a screenshot from the 2014 service manual. Oddly enough they show four.

Did you try using the magnetic flexible pickup tool ? I see you have tried with the flexible claw pickup tool. I think twine will be too limp. Maybe use tie wire instead with a noose like loop on the end but you will need to be able to see it and use the claw or the magnet to hold it.

Here is my experience with their customer service: Ordered a Gen 1 Morimotto triple fog light kit. One of the brackets was incorrectly packaged by the factory. There is only a slight difference in height. After a couple of emails to Adam explaining the situation a new pair of brackets were sent...

Here is one of the reroute threads. https://www.fordraptorforum.com/threads/wiring-harness-re-route.9648/ This is what I did.

I would recommend the Morimoto triple kit. Scroll down this sub form and you will find the link. White wide and Yellow wide pass SAE tests.

I don't know how much Mercon LV you will need for a flush or what the power steering system capacity is but if you have 1.5 + quarts left over you can use it to change the transfer case fluid in your 2013.

https://www.fcsdchemicalsandlubricants.com/Products/Details?cid=100&pid=300

I bought these. https://www.ebay.com/itm/161600211130?mkcid=1&mkrid=711-53200-19255-0&siteid=0&customid=link&campid=5338805043&toolid=20001&mkevt=1

21.5 mm lug nut sockets are available just for this problem. Get one and use it to remove them and replace as suggested above.

Ignition transformer capacitors. There to minimize radio interference caused by ignition coils. Looks like there is one on each side. C1544 & C1545 . Screenshots from the 2014 shop manual wiring diagrams.

From the service manual. Arrows indicate flow direction. "2014 F-150 Workshop Manual Located inside the transmission case is a thermal bypass valve. The thermal bypass is used to route fluid to the cooler when operating temperatures increase, or to return fluid directly to the transmission...

Inlet is on top. Outlet is on the bottom.

Torx plus 50

The south end is the town of Como. U.S. highway 285. Route length is shown as 20 miles. Head west on 285 to Fairplay then north on 9 for an easy return to Breckenridge. The Boreas Pass route mostly follows the old narrow gauge railway grade. There is a locomotive display at the start in...

Boreas Pass is scenic and an easy dirt road. Head back via 285 and 9. Georgia Pass is scenic more narrow between waypoint 3 and the pass with some lose rocks and ruts near the top. The 285 side is easy dirt. Detour at waypoint 4 North to Jefferson lake if you have time easy gravel road $7...

This is from another thread here. Torque 17.5 N m star pattern.

Both are heavy duty shovels. I have the Ironman. It is the equivalent of a full size shovel. Long enough to reach under a high centered vehicle to remove snow, mud or sand. You can use the d ring handle to shorten it. Comes in a heavy plastic case. The rounded edges are not as good as a point...

Here is a made in U.S.A. two piece shovel:https://www.amazon.com/dp/B01N45SKVR/?tag=fordraptorforum-20 Also an Australian style 3 piece shovel with case: https://ironman4x4america.com/3-piece-shovel-and-storage-bag/