Search results

4,555 miles and running strong.

This is the interior sensor they give when deleted. Empty box. Lol

@xlover were you able to get it done?

Install video. Rear took about 20 minutes each side. Super quick when you have the right bolts. Front want too bad, but did take a while. Breaking a tool added an hour.

Quality control inspections in the manufacture process.

@ricsan, I used the “BB” unit on a 23. Everything works perfect after apim program.

Done deal. 2.25” front, 1” rear. Rpg is good, but the rear bolt they send it 1” too short. Better pictures to come.

I took the wheel off to do perch collars and noticed the grease on the lower control arm.

Thanks. I'm happy it's useful. For sure, feel free to use. DM me if you have questions. Console trim piece pulls toward your leg, not up. I had to get a snack and reassess. Hanger is real. Lol I started a RPG perch and spacer vid last night. Hopefully, have it complete today. I'll post it in...

No issues leaving it plugged in or codes that I'm aware of. I'm sure the computer didn't "like" disconnected sensors, but it sure made it easier.

That's no bueno. I'm at 2600 miles and figured I made out of the leak zone. I'm going to need to keep hoping it doesn't happen. On another note, my R sat in the shop for a week due to a faulty CV axle.

1 video. Life happened and distracted me. It's 142 minutes in raw form. Should be available around 12:35 CST.

Drop it upon them like the non-40” tire peasants they are. Lol

On the new console, the sensors are better concealed behind the grills in front of the lights buttons.

Hey enjoy the ride, were you able to check your window sticker and see if you have it? I have an empty box in its place. Lol

If you have it, it should be included in this section of your window sticker. Or sit in, lock it with the remote, and start moving around. If your alarm starts, you probably have it.

There is a module above that piece. I don’t believe there is a way to add it easily. There’s also a module that goes in the rear driver side wheel well somewhere.

Ok. Cool. I’ll look at the apim numbers on my truck tomorrow and let you know. I do know if the apim isn’t programmed, the buttons won’t work.

Where did you get that part number from? That doesn’t look right.

Program the apim. It’s a different module.

Are you still looking? I have a set of rears from my old ‘19. $400 and they’re yours. 50k miles located in Houston.

If you’re still looking, I have the rears from my ‘19 I need to part ways with.

Well, went to install this morning and ran into a Ford quality snafu. Truck will be in the shop for a couple of days to replace the front cv axle. Boot leak slinging grease everywhere at 2500 miles.

The SCCM (clock spring) and HVAC control. I purchased them through boosted grey goose. The cup holder and bin light are factory parts. I ordered pieces from digikey to build the harness and jumper from the footwell light. Cup: ML3Z-1513562-CB, Bin: ML3Z-14A318-C Had to dremel a hole into the bin.