Search results

I have the Ford Spray in liner, it was sprayed in thick for sure but I don’t think it’s the issue in my case

In my bed, there’s a 400watt inverter in the rear driver side of the bed, where is the access panel located? If you had pictures that might help

Yep, I agree, I tried what I could to avoid the trip, but if it’s a bad actuator or module it’s on them, I’ll be dealing with it this week…

Yeah that’s up next I reset my forscan modules so next up this week will be a trip to the dealer

The DTC say internal electronic failure and open circuit. The Rear Gate/Trunk DTC says that it is likely the rear actuator. I believe that was what one of the earlier posts had mentioned the issue was as well. So I am hesitant to make any changes or reset the modules. I screenshotted the...

I’m seeing DTC codes in the Camera Rear Module, Trailer Module, and Rear Gate Trunk Module….

Yes but it’s a rats nest of wiring under there with the 400w amp harness under there…

I just posted a similar thread…I have 22’, my tailgate will not delatch, I get a ding when I hit the button. I have tried manual mode in sync and that does nothing, still receive the ding. I have unplugged the tailgate release and Module fuses. The beeping goes away but the tailgate will not...

About to….

Yes I have tried pushing it toward and pulling it, also from inside the box to

Just an update on this, I pulled the fuses for both the tailgate release and tailgate module. Neither worked... When I pulled the fuse for the tailgate module the dinging stopped at least, however, even set to manual mode, the tailgate would still not release. What I'm not sure I am...

The bed cover was installed but is above the tailgate and hadn’t been a problem the first 5k miles with it on, I’m going to try the fuse and forscan this weekend. I want to check forscan for error codes and double check my modules that I changed couldn’t be impacting it

I pushed the cable around a bit to see if that could help but no luck…. I did get a confirmation though on what happened last, my wife said the button was used last to open the tailgate, when the button was pressed to close it it beeped and wouldn’t close, so she manually lifted it up and...

The cable you mean? Potentially wrapped around the notch

Battery should be brand new…less than 10k miles. It’s started acting up after these recent Ford sync updates….

Still won’t work…just beeps

Hey Guys! This is something that has been happening consistently lately and for an extended period of time. I'm not sure what allows it to work, maybe sitting for a couple days it'll work randomly. However, my tailgate button on the back, inside the truck, and on the key fob will produce a...

I haven't gotten around to it sadly...was actually just thinking of it the other day like what's going to be my plan for fixing that, I was thinking maybe just a new bumper itself would be the way to go. Much more expensive fix going that route...I'm not sure if it is just adjusting a bracket...

I think the yellow bar in the middle is a lower power than the others, I've also gotten accustom to the DRL tails on a well.

On my truck I'd sling that all over the side it'd never stay on the tire

Yeah that was a question I had too on license plate lights. I think in forscan the option is to turn it on, when turning it on the tails are on as well as the parking lights.

agree, sounds it to me too

the 35s are fine with the 20s, plenty of tire, both are good options just depends on your application. I'm going to be mainly street driving, if I go off road, it isn't going to jumping or really anything sport or speed. I think if I lived out west or had more active trail systems near me I'd...

I would think since none of that is in the ACM then it shouldn't affect any thing sound wise. There is some changes that can be made in the ACM to effect the subwoofer and overall sound system, I'd think you'd be in the clear though with your changes.

I ordered a wheel and tire package right around black Friday from Custom Offsets, wasn't like an amazing discount going on but enough for me to pull the trigger at the time I didn't...wish I had seen the collars ahead of time, I would have order 37s instead of 35s. My thought now is once the...