Search results

Quality seems good so far.

Forged off-road sells the Saudi cooler. 200-205 on my trans with Saudi cooler pulling my camper.

I had a zroadz 20” in lower grill when I got the truck. Not bad it is comparable to most cheaper lights on the output and pattern side. I since have replaced it with a rigid and they is no comparison.

Make sure you replace coil boot and pellet when you do the tune up.

Prototype upper thanks to Jason from Great Lakes off-road

Old school rpg upper and Tie rod with KHC delete

I pull a 26ft with no problems but I put my bump stops down to help

Master flow Tsunami 1050 Is what I run works good for cheaper compressor. I filled an rv tire from 65 to 110 psi on my last trip. My buddy had a blow out on a rv and spare was low of coarse.

Thursday Friday not to busy Saturday was packed but not long travel round up packed Sunday ghost town

Got a little three wheel action

High or low best looking

I found a small jump

You can’t beat rcv best out there But cv’s are easy to change if you break one. I personally bring my old oem ones if I go hard wheeling. Just in case. Cause I don’t trust the Autozone ones yet. Fingers cross they have been holding so far.

I run dorman iwe deletes And Autozone cv’s. Just make sure the boots are neoprene. They withstand the heat better. I’ve had no issues with the truck being deleted. The dorman deletes have a grease zerk just grease a little every oil change. Autozone cv are lifetime warranty too. oem are...

Looks awesome great job

Watson racing out of Michigan sells them. They are a Ford Performance dealer. They were available in December when I checked

Cali offers the same lights you can buy off eBay from China. When I got my truck it had a zroadz 20” seemed decent but I’ve switched everything to rigid or Baja and there is no comparison.

At my work we run badlands on two of our scrap car trailers. They get used a lot. Normally about 3yrs and they stop working. They get abused pulling Inoperative vehicles up on the 3 place trailer.

Search but didn’t find anything Are the rpg uca and tie rod for a gen 2 the same as a gen 1 ? Found a deal on some just don’t know for sure if there the same. Thanks

I sent my shocks in 3k ago for a rebuild with flutter and #1 valve. I can’t speak bad of them. Emailed me and then called me right away. Had a 5 day turn around just like they said. flutter and valve is a very impressive upgrade over factory.

Pm sent

My raptor gets some attention but typically only by anyone that knows cars/trucks. my 11 gt500 is the same but the 69 mach 1 makes everyone look and ask questions. My OJ Bronco doesn’t get a look very often.

Pm sent

I run snap on amber covers on all my lights in snow or fog. Rigid makes them they work good.

If there is side wall cracking they are junk. In the tread not as big of a deal. I just wouldn’t take a road trip on them.