I ran mostly 2wd playing in the dunes, even without the paddle tires. They really toss some sand, that is for sure. Even with 600hp they were just a little too much paddle for the truck. What I was planning to do this year was have the paddles cut down slightly, so not so aggressive. But...
Actually Ford Motorsports had 6.2 cams which if I recall correctly was for the Raptor R that never happened. Used to see them on eBay but not sure if there are still anymore out there.
Here are some pictures after I modified my Stainless Works exhaust to run thru the bottom of bed behind rear wheel.
---------- Post added at 10:18 AM ---------- Previous post was at 10:17 AM ----------
I did that last summer and just posted some pictures.
I have most of that but did put on high flow cats. It is the system from Stainless Works. It has their headers, dual cats, X pipe and then originally did exactly what you said crossed over behind the axle and then was straight out the back. Last year I actually put holes in bottom of box...
I did the Roush gauge holder that goes in one of the a/c vents with just a vacuum / boost gauge. I special ordered from Autometer to look as close as I could to match the factory gauges. I did upgrade it to an LED bulk.
That is how they do it these days. Much quicker and better access. Plus the front clip does not come off like an old truck, inner fender / supports are welded on, just like most of cores support. You can't just unbolt it.
This is actually so common now that with the super duty trucks...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.