Does anyone have a good solution or have you experienced a sagging door panel? I've not came up with a good solution that's holding at this point. Would like some ideas/solutions for those that have dealt with this issue short of buying a new panel.
No upgrades whatsoever. Bone stock has a consistent service record so that’s a plus. Zero rust but it’s been beat up here and there. All fixable things just needs TLC.
Transfer case motor
Balljoints
Transmission (newest fun item)
Starter
Battery
Power washed interiors (wife has named truck stinky)
Putting sound deadening in all floors and doors now
Door actuator pass side
Mirror switch driver side
I’ll start a “build/rebuild” page since it’s a project...
It will. The drivetrain if maintained right is solid. I ran a company building on these powertrains and rebuilds usually didn’t happen until 400k miles in severe duty application with lots of idle time.
Now with that’s said I’m putting a new transmission in but this truck was beat on and is...
Well end result is new tranny something mechanical is broke. Was able to have Ford match tranny shop and extend coverage for 3 years unlimited mileage. Not ideal but I suppose I know what I have now. Thanks for all your help.
If anyone needs a leadframe the one I took out is good and...
Help! Facing some tranny issues whereas the truck will shift erraticaly across all 6 gears and then periodically hit 1st gear at speed causing the tires to chirp and vehicle to get sketchy. (Recall symptoms)
So I did the following...
1) Had the reprogram performed by Ford (Did not fix...
Happy to be here with a hard life raptor that’s still going strong. 250k miles on the 6.2L and is a fun project truck for $13k. Didn’t feel like I could go wrong at that price even with a few minor maintenance items.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.