Recent content by BAP84

Both. There is a manual (screwdriver) adjustment you do to set the proper level during the aiming procedure in the service manual. After that is set, suspension height/travel sensors tell a computer (headlight control module) what vertical adjustments to make to the headlight projectors to keep...

@Antho walked me through getting mine straightened out and from my point of view he is an absolute wiz with these Ford computers and FORScan/FDRS (way beyond my basic knowledge of programming little preferences through FORScan) thanks again to @Antho for the guidance... I’m not sure if the files...

@Antho should elaborate if he wants, but he checked in FDRS to confirm there was no available HCM updates for my truck and nothing was pending so he sent me 3 files which are the current firmware files on the 2023 HCM’s I believe (not sure if it’s a Raptor specific file set or applicable to all...

Fixed thanks to @Antho

I use Iron-X and a Mr Clean Magic Eraser when they get bad. However after the last time I cleaned them I ceramic coated them and they clean up a lot easier since doing that. Here’s a before and after of the tips on my 21

Curious if anyone else has this issue on their Gen3...I've found one other post related over at the F150Gen14 forum but no conclusion to the issue in that thread. I have an October 2021 build 801A (LED headlights) and I've always thought the headlights didn't adjust correctly to weight in the...